navitron
 
Renewable Energy and Sustainability Forum
UK's most popular Renewable Energy Forum May 24, 2012, 03:44:40 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Anyone wishing to register as a new member on the forum is strongly recommended to use a "proper" email address - following recent spam/hack attempts on the forum, all security is set to "high", and "disposable" email addresses like Gmail, Yahoo and Hotmail tend to be viewed with suspicion, and the application rejected if there is any doubt whatsoever
 
Recent Articles: UPDATE ON DECC APPLICATION FOR LEAVE TO APPEAL TO THE SUPREME COURT | Yingli Green Energy's PV Module Ranks No.2 in TUV Rheinland Energy Yield Test | Navitron Solar Showers at Glastonbury for Year 5!
   Home   Help Search Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Draining down risks  (Read 321 times)
watford 99
Newbie
*
Offline Offline

Posts: 20


« on: September 21, 2011, 12:37:44 PM »

Yet another basic question I'm afraid.

If I drain down my 20 tube system and do not refill until a couple of days later and the sun shines am I likely to do damage to the manifold or other parts due to overheating.  Covering the tubes might not be too easy.
Logged
desperate
Hero Member
*****
Offline Offline

Posts: 648


Me and Microdesp cremating something to eat.


WWW
« Reply #1 on: September 21, 2011, 07:26:30 PM »

Probably not, but no guarantees given.

Desp
Logged

Crazy old duffer
greentangerine
Full Member
***
Offline Offline

Posts: 173



« Reply #2 on: September 21, 2011, 09:07:57 PM »

I think I remember the instructions that came with my kit said not to install the heat pipe tubes until the system had been filled but I can't find that piece of paper right now.

Anyway, when I extended the system earlier this year I covered the existing tubes when the system was drained down and I was installing another manifold.

If your tubes are the U type which contain fluid, then you probably can't drain it down anyway without removing them.
Logged

2.94 kWP (Sharp ND210 / SB2500)
65 x Ø58mm SunnPro / Torrent T280 RE OV
11kW Dean Forge Croft Clearburn with 10,000 BTU boiler.
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!