navitron
 
Renewable Energy and Sustainability Forum
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Anyone wishing to register as a new member on the forum is strongly recommended to use a "proper" email address - following recent spam/hack attempts on the forum, all security is set to "high", and "disposable" email addresses like Gmail, Yahoo and Hotmail tend to be viewed with suspicion, and the application rejected if there is any doubt whatsoever
 
Recent Articles: Navitron Partners With Solax to Help Create A More Sustainable Future | Navitron Calls for Increased Carbon Footprint Reduction In Light of Earth Overshoot Day | A plea from The David School - Issue 18
   Home   Help Search Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Mastervolt Soladin 600 tripping  (Read 989 times)
Caulkhead
Newbie
*
Offline Offline

Posts: 1


« on: August 31, 2017, 10:12:51 PM »

I need a little assistance with "over grid volts" fault code.
I have the wizard software and have connected successfully but I can't find the setting to change the grid volts threshold.
When monitoring the grid volts I have a healthy 249v and understand the unit should be able to harmonise up to 253v.
Do I need different software? Any advice will be appreciated.
Logged
holhead
Newbie
*
Offline Offline

Posts: 4


« Reply #1 on: January 22, 2019, 09:47:04 AM »

Have the same problem but no connection or software to correct it if that were possible...
Logged

1kWp BP MSX 120 and 1kWp Sharp plus solartwin SHW
marshman
Hero Member
*****
Offline Offline

Posts: 938


WWW
« Reply #2 on: January 22, 2019, 11:31:08 AM »

There is a separate "section" in the wizard software to access the "G83" bits. i.e. set all the disconnect parameters. They are hidden to stop people tampering. Before you delve deeper have you checked you have a decent connection to the grid and that you are not developing a significant volts drop from you incoming meter connection to the Soladin. As I recall the inverter comes fitted with a 13A plug (not sure that ever complied with the regs!) and if just plugged into a convenient socket could result in enough volts drop at full (ish) load to trip out on voltage. (easiest is to check the mains volts at the inverter with a decent DVM). I also recall that the Soladin was quite trigger happy - especially if not set to the right territory - i.e. UK G83.

If you still have problems PM me and I'll tell you how to get into the "hidden" section.

Roger
Logged

3.15kWpk (15xSharp ND210)/SB3000. & 3.675kWpk (15 x Suntech 245WD)/SB4000TL, 10kW GSHP driving Wirsbo underfloor heating from 1200m ground loops. 10' x 7' solar wall (experimental). Clearview 650 Wood Burning Stove. MHRV - diy retrofit. Triple glazing.
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
SMFAds for Free Forums
Simple Audio Video Embedder
Valid XHTML 1.0! Valid CSS!