navitron
 
Renewable Energy and Sustainability Forum
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Anyone wishing to register as a new member on the forum is strongly recommended to use a "proper" email address - following recent spam/hack attempts on the forum, all security is set to "high", and "disposable" email addresses like Gmail, Yahoo and Hotmail tend to be viewed with suspicion, and the application rejected if there is any doubt whatsoever
 
Recent Articles: Navitron Partners With Solax to Help Create A More Sustainable Future | Navitron Calls for Increased Carbon Footprint Reduction In Light of Earth Overshoot Day | A plea from The David School - Issue 18
   Home   Help Search Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Problem with Seitron 2+ 1 channel relay  (Read 401 times)
TonE
Newbie
*
Offline Offline

Posts: 7


« on: October 05, 2017, 03:33:35 PM »

Our heating is split into two zones each controlled by a Seitron DLP 201 M00 0SE 2 + 1 Relay Module which has worked flawlessly since installed in 2010.

However now the channels/circulator pump/signal strength LEDs have started continuously flashing quickly. The power green LED has remained constantly lit and is not flashing.

The troubleshooting section in the instruction manual doesn't mention all LEDs flashing as an error condition, however it does state that either of the channel indicator LEDs will flash when the channel is in alarm state and not receiving a signal.

I've replaced the batteries in both thermostat transmitters but this didn't help.

Any help or advice on what else I can try very much appreciated!

Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
Simple Audio Video Embedder
Valid XHTML 1.0! Valid CSS!