Renewable Energy and Sustainability Forum
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Anyone wishing to register as a new member on the forum is strongly recommended to use a "proper" email address. Following continuous spam/hack attempts on the forum, "disposable" email addresses like Gmail, Yahoo and Hotmail tend to be viewed with suspicion, and the application rejected if there is any doubt whatsoever
Recent Articles: Navitron Partners With Solax to Help Create A More Sustainable Future | Navitron Calls for Increased Carbon Footprint Reduction In Light of Earth Overshoot Day | A plea from The David School - Issue 18
   Home   Help Search Login Register  
Pages: [1]   Go Down
Author Topic: inverter to supply heat-pump  (Read 2109 times)
Full Member
Offline Offline

Posts: 222

« on: November 04, 2006, 09:15:14 PM »

Hi all,

Sorry if this has been covered elsewhere, I run a search, but can't find an answer...

Can anyone say if a heat pump can run off a modified sinewave inverter, or should I use a pure sine wave inverter?

Thanks in anticipation

« Reply #1 on: November 12, 2006, 04:50:37 PM »

Not sure. I assume you could run from a modified sine wave inverter, but cannot say for sure.

Please also bear in mind that the inverter must be able to supply significantly more than the rated input of the compressor - this is due to the large start up surge for compressors, also, bear in mind that it is a highly inductive load

Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
SMFAds for Free Forums
Simple Audio Video Embedder
Valid XHTML 1.0! Valid CSS!